Omnipure K2540 JJ Inline Filter




Drink purified and refreshing water from the Omnipure K2540 JJ Inline Filter

  • MPN: K2540 JJ
  • 10″ x 2″ Carbon block inline filter
  • JJ – Quick Connect
  • Designed and Made in USA
  • Manufactured by Omnipure
  • Captures particles greater than 5 microns
  • Reduces chlorine, taste, odours
  • Needs replacing every 5,678 Litres
  • Runs at 3 lpm
  • System Tested and Certified by NSF International against ANSI / NSF Standard 42 for the reduction of Chlorine, Class 1 and Taste and Odor.

Visit WA Water Filters for Replacement Filters in Perth, WA – Phone: (08) 6156 0220


Additional information

Weight 0.8 kg
Dimensions 25.4 × 5 × 5 cm
Service Life

1 Year

Filter Media

Coconut Shell Granular Activated Carbon (GAC)


1/4″ Female Quick Connect (inlet and outlet)

Operating Temperature

For installation on cold water lines only (40 – 100 F)


Chemical and Mechanical Reduction


Carbon Block

Flow Rate


Omnipure K-Series Model


Filter Size

10" x 2"

Micron Rating


Reduction Claim

Chlorine, Taste and Odours



Omnipure is a world class manufacturer of inline water filters and filter cartridges in the USA. They produce over a dozen unique series of filters offering solutions to nearly any point of use water filtration problem.


Flow Rate 0.5 gpm
Maximum Operating Pressure 125 psig
Operating Temperature 2 to 38 ºC35 to 100 ºF
Rated Capacity 1,500 gal/1 Year
Reduction Claim Chlorine, taste, color, and odor reduction
Flow Capacity 1,500 gal


Maintenance Requirements

  • Note flow direction of the Omnipure K2540-JJ.
  • Flush the new Omnipure K2540-JJ with 5 gallons of water prior to use and check for leaks. If leaks occur, check tightness of tubing and fittings. If leaks persist, discontinue use and call your supporting dealer.
  • Replace the Omnipure K2540-JJ when rated capacity  is reached, or when flow becomes too slow.
  • Install in compliance with state and local laws and regulations.

Additional Information

Cap and body are spin welded together producing a smooth, consistent seal without the use of glues or binders that can cause contamination. The result of these design and production techniques is a reliable filter that is fast and easy to install.

One of the primary uses of this product is as a system component. The benefit is derived from the fitting being molded directly into the filter cap, greatly reducing clearance. Shown here (right) is a reverse osmosis system with the traditional 12 in x 2.5 in filter configuration. Notice that all the filters are uniformly attached. This results in the most efficient use of available space and greater filtering performance in a smaller overall area.

You may also like…