Omnipure K2505 JJ Inline Filter


  • Omnipure K2505 JJ Inline
  • Sediment Inline Filter
  • 1/4″ JJ Quick Connection
  • Omnipure K-Series Model
  • 10″ x 2″ Filter Size
  • Captures particles greater than 5 microns
Specs Sheet


This is the K-Series Omnipure K2505 JJ Inline Sediment Filter.

  • Sediment Inline Filter
  • MPN: K2505 JJ
  • 10″ x 2″ Inline Filter
  • Manufactured by Omnipure
  • Made in the USA
  • 5 Micron pore size
  • Highly effective at reducing Dirt, sand, and sediments from potable drinking water, as well as other contaminants.
  • Listed under ANSI / NSF Standard 42 for materials only
  • Protects other cartridges, helps standardize beverage quality at disparate locations, and reduces maintenance problems in water-using equipment.

Additional information

Weight 0.8 kg
Dimensions 25.4 × 5 × 5 cm
Service Life

6 Months

Operating Temperature

For installation on cold water lines only (40 – 100 F)

Flow Rate

2.8 LPM


JJ Quick Connect 1/4"

Maximum Pressure

8.6 bar

Omnipure K-Series Model


Filter Size

10" x 2"

Micron Rating


Reduction Claim

Sediments (Dirt, Rust, Sand, Silt)



Omnipure is a world class manufacturer of inline water filters and filter cartridges in the USA. They produce over a dozen unique series of filters offering solutions to nearly any point of use water filtration problem.


Flow Rate 0.5 gpm
Maximum Operating Pressure 125 psig
Operating Temperature 2 to 38 ºC35 to 100 ºF
Rated Capacity Dependent on Influent Water Quality
Reduction Claim Dirt, sand, and sediment reduction
Flow Capacity Dependent on Influent Water Quality

Performance Data Sheet.pdf


  • Pre-filtration for RO
  • Drinking fountains
  • Ice Machines
  • Other point-of-use application


  • Fine filtration of treated drinking water to ingredient water quality
  • Helps standardize beverage quality at disparate locations
  • Reduces maintenance problems in water-using equipment
  • Removes more than 96% of sediment
  • Filters out fine particulates, including dirt, rust, oxidized iron manganese and sulfide

Maintenance Requirements

  • Note flow direction of filter.
  • Flush new cartridge with 5 gallons of water prior to use and check for leaks. If leaks occur, check tightness of tubing and fittings. If leaks persist, discontinue use and call your supporting dealer.
  • Replace cartridge when rated capacity is reached, or when flow becomes too slow.
  • Install in compliance with state and local laws and regulations.

Additional Information

Cap and body are spin welded together producing a smooth, consistent seal without the use of glues or binders that can cause contamination. The result of these design and production techniques is a reliable filter that is fast and easy to install.

One of the primary uses of this product is as a system component. The benefit is derived from the fitting being molded directly into the filter cap, greatly reducing clearance. Shown here (right) is a reverse osmosis system with the traditional 12 in x 2.5 in filter configuration. Notice that all the filters are uniformly attached. This results in the most efficient use of available space and greater filtering performance in a smaller overall area.

You may also like…